Self-Sorting 4-in-a-Row Travel Box + Checkers
3D printable decor piece · STL file
- Marketplaces
- 5
- Files
- STL · 3MF
Free download for personal use on MakerWorld & Printables.
Selling prints needs a commercial licence: it comes with membership.
About this model
A 4-in-a-row that's actually small, and cleans up after itself.
Pull the pin and the whole board empties at once. Every piece finds its own compartment: rounds come out the front, squares go to the back. No sorting by hand.
Lay the board on top, slide the pin through, and it's a flat little box, 15 × 18 × 2.2 cm, that goes in any bag. Flip it over: the bottom is an 8 × 8 checkerboard, and the same pieces play checkers.
It took 18 prototypes to get the sorting right. No supports, no glue, no hardware.
WHAT YOU PRINT • Box with the checkerboard on the bottom • Board (7 × 6 grid) • 21 squares + 21 rounds (16 mm) • Pin: it releases the pieces and locks the box
PRINT SETTINGS PLA, 0.2 mm layers, 15% grid infill, no supports. Bambu Lab A1 profile, 4 plates: • Plate 1, box with checkerboard: 3 h 32 min, 106 g (2 colours, AMS) • Plate 2, board: 5 h 36 min, 118 g • Plate 3, 21 squares: 37 min, 13 g • Plate 4, 21 rounds + pin: 44 min, 16 g Total: about 10.5 h and 253 g. Fits any 256 × 256 bed. The box is 182 mm long, so it won't fit an A1 mini. No AMS? Use the one-colour profile. The game works exactly the same; the checkerboard just isn't coloured. Included: 3MF for Bambu Lab A1 (AMS and one-colour), 3MF for Creality K2 (colour and one-colour), STL of every part.
HOW TO PLAY 1. Stand the board in the slot of the box and slide the pin in. 2. Take turns dropping pieces. First to get four in a row (across, up or diagonal) wins. 3. Pull the pin and watch them sort. Drop the squares with the little circle facing away from the 4-IN-A-ROW lettering.
Checkers: close the box and flip it over. 12 rounds vs 12 squares on the dark squares; stack two for a king. Bonus, Corners: 9 pieces each in opposite 3 × 3 corners. First to move all of them into the other corner wins.
PACKING UP Rounds go step-down into the 21 holes, squares into the 7 slots (3 per slot). To take a square out, slide it toward the center of the box with a fingertip. It rides up a little ramp so you can pick it up.
TIPS • After printing, drop one square into each column. It should fall straight through. If one catches, trim the stray string at the pin hole. • If a piece ever stops halfway, a light tap on the board sends it on. • Colour bleeding into the light squares? Increase the flushing volumes in the slicer.
Free for personal use. Selling prints? Message me for a commercial license. Printed one? Post a make, I'd love to see your colours 🧩
Printing tips
- Check the slicer notes on the model page.
- Matte PLA suits most decor pieces.







